Several problems may arise with your Beko fridge freezer. These include faulty temperature control thermostats and condenser fan problems. Luckily, there are several ways to troubleshoot these problems. These simple steps will save you a lot of money in the long run.
Problems with a faulty condenser fan
Faulty condenser fans can ruin the performance of your fridge freezer. This can cause your fridge to cool too slowly or to overheat. The first step to fixing a faulty fan is to clean it. You should take a paintbrush to remove any debris or grime collected on the fan. You should also make sure that the fan blade moves freely. If it is stuck or binds, it’s time to replace it.
Sometimes, it is possible to fix a faulty condenser fan yourself. However, this is often not a cost-effective solution. Besides, you’ll need to purchase spare parts and call a technician. To ensure you can get the fridge repaired and not spend a lot of money, it’s best to seek assistance from a professional technician.
Another common problem that Beko fridge freezers face is a faulty compressor. This can be caused by a bad capacitor or a broken wire. To test the compressor, switch off the freezer and open the door. If the fan stops after 10 seconds, the compressor is probably faulty.
If you can’t find the condenser fan, try checking the evaporator fan. This component is located behind the rear panel. If the fan is noisy, you need to replace it. After a few days, the freezer should normally run again. If it still doesn’t work, the faulty fan may have become stuck.
Another problem related to the faulty condenser fan is a knocking noise from the back of the fridge. This sounds like the fan isn’t working correctly, which can cause the condenser coil to overheat and make it difficult for the fridge to cool. The knocking noise could also be caused by the condenser fan coming into contact with the ice or other objects inside. Before you replace the fan, it’s best to unplug the power to the fridge to access the parts.
Problems with a faulty temperature control thermostat
The temperature control thermostat could be the culprit if your Beko fridge freezer has indefinite cycling. This control can be found on the control panel of the refrigerator and can be easily replaced. It is usually located on the bottom of the fridge control panel. To access the thermostat, you must remove the control panel door and the metal casing that holds the thermostat. Next, test the thermostat’s wires for continuity. It is time to replace the control if it displays an infinity reading.
There are several reasons why the thermostat is defective. A faulty thermostat could cause a fridge to run too hot or too cold, or vice versa. If you have a Beko fridge freezer that has a temperature control thermostat, there are several things you can check to determine the exact cause of this problem. One of the most common causes is a blocked vent or sensor. You can also try moving the food away from the fridge’s vents and sensors. You can also try letting the fridge run for a while. This will help the fridge stabilize its temperature.
Another reason your refrigerator’s temperature control thermostat fails is a clogged evaporator fan. It is essential to remove the panel so you can access the fan and the wiring. Then, use a multimeter to check the wiring of the motor. If you see any infinity readings, the motor is faulty.
A faulty temperature control thermostat in a Beko fridge freezer can be a complex issue to diagnose. If you don’t have the time or patience to diagnose the faulty element, the best solution is to contact a Beko fridge repair technician. Even if this is an expensive repair, it will save you money in the long run.
Faulty temperature control thermostats are also responsible for freezing food freezers. If this happens, you should try increasing the temperature of the freezer. You should consider replacing the thermostat if it is still not freezing food.